Analog Tap Tempo

Paul Anderberg

Paul Anderberg

Member
So I have a Panther Cub's Tap Input linked to Fn Switch 3 of the PBC and I can see the correct tempo being tapped into the Panther Cub when I switch to a new tempo, but for some reason, it always defaults to the longest delay time the Panther Cub has immediately after all the taps.

Fn Switch 3 is set to Momentary, 100 ms momentary time and the Auto Tap is set to 4 taps and to Macro 0 which is as follows:
Audio / FnSwitch #3 off:OFF, on:ON

Oh, and I'm on Firmware 3.1.2.

Am I missing something?
 
Not sure what that would be, your settings look good assuming that the pedal takes a momentary, normally open tap input. I checked the Panther Cub manual and it doesn't really give any information on what its tap tempo requirements are. I recommend checking with JHS to see if you can get more information on the pedal's tap input.
 
Yeah, I thought it was odd too. I tried normally closed and it defaulted to a VERY fast tempo, tried changing the amount of taps and how long the momentary is, neither had any positive effect. I'll check with JHS.
 
You must log in or register to reply here.
Back
Top