cosmic_ape
Active Member
I am not sure what I am doing wrong. I wanna add two buttons to scroll through my pages.
I checked the wiki file, set the polarity on II and set the switch as 'momentary'. I powered it with my existing isolated power supply. I have tried setting it as a regular Page button and as an IA button. Nothing! I even copied a different IA page button onto one of the External Switch buttons. No response.
I tested it with at least three separate TRS cables by different manufacturers to no avail. It briefly worked at the beginning, but only one button did (Button A, Page Up), and it was scrolling the pages the opposite way! When I unhooked the TRS cable, I noticed a page change on the unit, but that was it. It didn't work at all after that.
I saved my file and updated the firmware. I re downloaded the file into the unit and tried again. No dice!
Please help.
I checked the wiki file, set the polarity on II and set the switch as 'momentary'. I powered it with my existing isolated power supply. I have tried setting it as a regular Page button and as an IA button. Nothing! I even copied a different IA page button onto one of the External Switch buttons. No response.
I tested it with at least three separate TRS cables by different manufacturers to no avail. It briefly worked at the beginning, but only one button did (Button A, Page Up), and it was scrolling the pages the opposite way! When I unhooked the TRS cable, I noticed a page change on the unit, but that was it. It didn't work at all after that.
I saved my file and updated the firmware. I re downloaded the file into the unit and tried again. No dice!
Please help.