Building a new rig and need some suggestions

S

sbanville

Member
Hello all,
I'm new to the forum and to RJM music. I have taken on a long awaited project of building my dream rig from scratch and did the labyrinth of cables near from pedal board. I have a Bogner XTC classic, a TC G-Major, and RG-16, and VoodLabs GCP, and will be picking up a Dunlop Rack Wah. I also plan to incorporate some stomp boxes, Keeley compressor, and maybe a tube screamer. I am using a Palmer direct for live shows. I also want to be able to route the signal from my Piezo to the P.A. Can someone suggest a routing method that would allow me to channel switch my amp, bring in FX from the TC and switch between routing my signal between the amp and the P.A. Also since the Dunlop is not midi controlled, what is the best method for adding thi to the signal chain before the amp.

Thanks,

Steve
 
I have a few questions before I can suggest a wiring scheme:

Is the piezo wired as a separate output or on the ring of a stereo jack?
Are any effects going to be applied to the piezo signal?
 
You must log in or register to reply here.
Back
Top