Re: Debugerr "Unable to Contact Board 4" Can't PC, GetPrst n
Hi
Thanks for getting back to me.
The chain of events went like this:
1. I programmed the MMGT16. Everything was working. I did multiple Get Preset Name sessions...no hiccups.
After a few days....
2. I went to do a Get Preset Names, because I changed some presets on the Axefx2.
3. When I pressed start, the progress bar did nothing and MMGT16 went into a lock state.
4. Recycled power on MMGT16/Axefx2. Pressed some preset switches on MMGT16, but presets didn't change on axefx2.
Tried Get Preset names. Same event lock state.
5. I set MMGT16 back to factory default and reloaded firmware.
6. Then setup a fresh axefx2 device.
7. Went to get preset names...same lock state.
On the third try of step 5,6,7, I power cycled the axefx2 during the preset read session. Communication and preset reading started functioning.
The MMGT16 and axefx2 seem to be working together fine now.
However, while switching patches yesterday, all the displays (except) the main display went blank.
I power cycled the MMGT16 and everything came back.
I don't know why that happened...hope it doesn't happen during a gig..yikes.
Thanks for all of your quick replies...I really love the unit.
Dave