DMMTT In Stereo Loops

[Mkuebbeler]

7-10 loops go as follows
L7 H9
L8 DMMTT
L9 H9
L10 Ventris

I get sounds/effects out of everything EXCEPT the DMMTT. I don’t even get sound from the DMMTT unless I have it set with the purple LED, however I get ZEREO delay from it.

Any ideas? Every loop is using the correct cables. Does the DMMTT need to be in loop 7 since it’s the only mono pedal going stereo?

 

[rjmmusic]

Is the pedal wired as recommended in this article?

http://www.rjmmusic.com/2016/03/29/using-stereo-pedals-with-the-mastermind-pbc/

 

[Mkuebbeler]

Is the pedal wired as recommended in this article?

http://www.rjmmusic.com/2016/03/29/using-stereo-pedals-with-the-mastermind-pbc/

It should be correct yes.
L7 has has stereo in/out to TRS.
L8 has the mono cables to TRS.
L9 has stereo in/out to TRS.
L10 has stereo in/out to TRS.

I get sound from both left and right, just no delay and sound is only active in L8 when the LED is purple.

 

[rjmmusic]

When mixing mono and stereo pedals, a mono pedal needs specially wired cables to prevent it interfering with the stereo signal. The article describes how they need to be wired.