GT doesn't always reflect the fx in an Axe-Fx preset correctly

A

Alexander

Well-Known Member
When switching to another Axe-Fx preset, the GT/MM sometimes lits an effects IA, even though that effect is not present in the preset.

Example:
Preset 1 has a Drive block and its IA button is lit.
Preset 2 doesn't have a Drive block.
When switching from 1 to 2, the Drive IA sometimes stays lit.

Also happens with X/Y states of the AMP block.

Example:
In preset 1 AMP 2 is set to Y.
On the GT an IA is set to AMP 2 X/Y.
When switching to preset 1, the IA sometimes doesn't show that the state is Y.

These errors are not constant.

Any clue why this is happening?
 
Maybe. TBH I can't recall if this happened pre-3.0 as well.

Happens with preset switching as well as scene switching.
 
Ok, I've tried it with an XLII+ running Quantum 1.0 and was unable to reproduce the problem. I created two presets, one with a drive block, one without. Also two presets, one with Amp X and one with Amp Y. In my testing, it didn't get out of sync.

Can you send me your settings so I can try them out?
 
Weird, past few days it didn't happen. Gremlins ...
I'll keep an eye on it, and mail you the settings if it happens again.
 
Just posted firmware 3.0.1 that probably fixes some relevant issues (even some that were not fixed in the last build I sent you)
 
You must log in or register to reply here.
Back
Top