jgrantreynolds
Member
Signal chain:
Effects Gizmo:
L1: Pedal
L2: Pedal
L3: Pedal
L4: Pedal
Out 1-4/In 5-8: Volume Pedal
Loop 9: G-Major 2 (running to FX loop of amp)
All above controller by MMGT16.
I have six user presets on my G-Major 2. Setting these up as IA buttons on the GT16 was no problem at all, so the GM presets basically act as stompboxes.
What I would like to do is integrate the G-Major 2 presets into presets defined on the GT16. I have tried it in a number of ways:
1. Setting presets on the GT regularly as if the GM presets were stompboxes, so I just enable their corresponding button in the MMGT editor.
2. Setting the GT16 preset to send the corresponding PC to the G-Major 2.
In each case, I can see the G-Major 2 attempt to change presets momentarily, but it will default back to user preset 1.
I'm curious as to why this shouldn't work, especially in test scenario #1. If G-Major 2 presets are able to be recalled by an IA button, why wouldn't I be able to group these into a preset on the MMGT16?
Effects Gizmo:
L1: Pedal
L2: Pedal
L3: Pedal
L4: Pedal
Out 1-4/In 5-8: Volume Pedal
Loop 9: G-Major 2 (running to FX loop of amp)
All above controller by MMGT16.
I have six user presets on my G-Major 2. Setting these up as IA buttons on the GT16 was no problem at all, so the GM presets basically act as stompboxes.
What I would like to do is integrate the G-Major 2 presets into presets defined on the GT16. I have tried it in a number of ways:
1. Setting presets on the GT regularly as if the GM presets were stompboxes, so I just enable their corresponding button in the MMGT editor.
2. Setting the GT16 preset to send the corresponding PC to the G-Major 2.
In each case, I can see the G-Major 2 attempt to change presets momentarily, but it will default back to user preset 1.
I'm curious as to why this shouldn't work, especially in test scenario #1. If G-Major 2 presets are able to be recalled by an IA button, why wouldn't I be able to group these into a preset on the MMGT16?