Robert Payne
Well-Known Member
Hi Ron, I'm sure this is covered somewhere, but I couldn't find it. I have the AXE FX III setup as a device and buttons are assigned to blocks. They turn on and off if I click the button, but they don't "obey the GT22 button state" as a preset. (Presets are standard presents to recall loops on the Hex.)
So if the preset doesn't have a block on, I engage the assigned button and the block stays on until I click off the button. Voodoo Lab Hex works perfectly recalling the loop on preset and buttons assigned to CC# IA. Any ideas?
So if the preset doesn't have a block on, I engage the assigned button and the block stays on until I click off the button. Voodoo Lab Hex works perfectly recalling the loop on preset and buttons assigned to CC# IA. Any ideas?