IA Cycle

M

Manne

Member
Hi,

I wanna set up one bottom of the PBC for selecting 3 different presets of the Strymon Mobius.....

It should activate the Loop, the Mobius is inserted, then cycle though the presets, and if possible also

deactivate the Loop again.

Any help is appreciated

Thx
 
You could do something like the following - we'll say for this example that the Mobius is in loop 7.

Audio / Loop 7 - off:None on:ON
Mobius / PC - off: None on:1
System / Step
Audio / Loop 7 - off:None on:ON
Mobius / PC - off: None on:2
System / Step
Audio / Loop 7 - off:None on:ON
Mobius / PC - off: None on:3
System / Step
Audio / Loop 7 - off:None on:OFF

This will make four steps, the first three select different presets on the Mobius, the last one turns off the audio loop. Be sure to turn on IA Cycle for the button.
 
Thank you Ron,

that works nicely so far.
Would it also be possible, to initialize the cycle by changing the presets ?

My current layout is:
Loop 1 - Clean
Loop 2 - Crunch
Loop 3 - Rock
Loop 4 - Lead

So, by pressing any Loop bottom 1- 4, returning back to initial state of the preset, the Mobius off (red color for Mobius IA)
If engaging IA Bottom for the Mobius again, the cycle sequence should start again at the beginning (00A-00B-01A)
 
Yes, if you set "Update on Preset Change", then you can store a state for the button on each preset. (The default state would be loop 1).
 
I have worked out that I can have an alternative preset for the same button which almost acts as a cycle for me an my use.
I wanted to go from drive 1 to change to drive 2 using the same button.
 
You must log in or register to reply here.
Back
Top