need some direction on programming my Mastermind to my Kemper.
So, my current rig consists of a Kemper profiler and Headrush Looper Board. I have managed to get my MMGT to speak to and send commands to my Kemper as well as the Headrush. My problem however is, I want my Mastermind to simultaneously start recording on my Headrush and switch my effects/rigs in my Kemper. So far, I have managed to get my Headrush to carry out both recording immediately and my rig will change in my Kemper, but there is a rather serious delay in the change which poses a problem in my ability to line my tracks up when looping.
What's happening is my Headrush will do its job, but my Kemper is late to the party, so to speak.
Any recommendations on how to correct these latency issues?
So, my current rig consists of a Kemper profiler and Headrush Looper Board. I have managed to get my MMGT to speak to and send commands to my Kemper as well as the Headrush. My problem however is, I want my Mastermind to simultaneously start recording on my Headrush and switch my effects/rigs in my Kemper. So far, I have managed to get my Headrush to carry out both recording immediately and my rig will change in my Kemper, but there is a rather serious delay in the change which poses a problem in my ability to line my tracks up when looping.
What's happening is my Headrush will do its job, but my Kemper is late to the party, so to speak.
Any recommendations on how to correct these latency issues?