Hi.
I have made a page on the PBC to open and close blocks in the Helix.
The Helix is in loop 4 of the PBC.
I have assigned Footswitch 1,2 and 3 on the PBC Helix page to open block 1,2 and 3 on the Helix and loop 4 on the PBC.
The problem i have is that if i have Footswitch 1 and 2 on to put Blocks 1 and 2 on the Helix and i decide to close Block 1 by turning off Footswitch 1, i automatically close loop 4 on the PBC and i cannot hear block2.
I then need to turn off and on Footswicth 2 on the PBC to reopen loop 4.
Is there a way where each time i put on one of Footswich 1,2 or 3, loop 4 would open and stay open until all and only when the 3 footswicths are at off?
I have made a page on the PBC to open and close blocks in the Helix.
The Helix is in loop 4 of the PBC.
I have assigned Footswitch 1,2 and 3 on the PBC Helix page to open block 1,2 and 3 on the Helix and loop 4 on the PBC.
The problem i have is that if i have Footswitch 1 and 2 on to put Blocks 1 and 2 on the Helix and i decide to close Block 1 by turning off Footswitch 1, i automatically close loop 4 on the PBC and i cannot hear block2.
I then need to turn off and on Footswicth 2 on the PBC to reopen loop 4.
Is there a way where each time i put on one of Footswich 1,2 or 3, loop 4 would open and stay open until all and only when the 3 footswicths are at off?