Hi all.
About to re-build the WDW rig & wanted to get a 'sanity' check from you all - how does this look?
Idea:
- running a Klon in loop 1
- Rockaway Archer in loop 2
- Axe FX III as "pre" in loop 3 (wah, phasers, fuzzes etc)
- Bogner Fish preamp in loop 5
- CAE 3+ in loop 6
- Axe FX III "post" in loop 7 - stereo outs (delays, reverbs etc)
- Eventide Eclipse in loop 8 - stereo outs
- RJM mini line mixer to receive the stereo outs from loops 7 & 8 - this goes into a VHT 2/90/2 power amp
- the 'dry' part of the tone comes from Out8 & goes to the effects return of a JCM800 head
QUESTIONS:
1. Do i need to connect 'output 1-4' to 'CS in'?
2. Can i use a TS cable from 'out8' to the effects return of the JCM800 to get my "dry" signal?
3. Is there an easier way to do this? Should i just put the preamps in the send/returns of loop 5 & 6??
About to re-build the WDW rig & wanted to get a 'sanity' check from you all - how does this look?
Idea:
- running a Klon in loop 1
- Rockaway Archer in loop 2
- Axe FX III as "pre" in loop 3 (wah, phasers, fuzzes etc)
- Bogner Fish preamp in loop 5
- CAE 3+ in loop 6
- Axe FX III "post" in loop 7 - stereo outs (delays, reverbs etc)
- Eventide Eclipse in loop 8 - stereo outs
- RJM mini line mixer to receive the stereo outs from loops 7 & 8 - this goes into a VHT 2/90/2 power amp
- the 'dry' part of the tone comes from Out8 & goes to the effects return of a JCM800 head
QUESTIONS:
1. Do i need to connect 'output 1-4' to 'CS in'?
2. Can i use a TS cable from 'out8' to the effects return of the JCM800 to get my "dry" signal?
3. Is there an easier way to do this? Should i just put the preamps in the send/returns of loop 5 & 6??