travis_38
Active Member
I am noticing that when I am on my Loops page, switching any pedal on or off seems to cut the output for a split second which is very obvious when I am using a long decay reverb and or delay (which is almost always).
To be more specific:
Loop 4: Dunes
Loop 9: Timeline (stereo in/out, in series)
Loop 10: Timeline (stereo in/out, in series)
Imagine I strum a huge chord with both loop 9/10 on, the reverb and delay tails are trailing off for several seconds and I turn Loop 4 on/off repeatedly... every time I do this the delay/verb trails are "dropping" for a moment.
Is this expected behavior? Is there anything I can do to prevent this, outside of putting the Strymons after the PBC?
To be more specific:
Loop 4: Dunes
Loop 9: Timeline (stereo in/out, in series)
Loop 10: Timeline (stereo in/out, in series)
Imagine I strum a huge chord with both loop 9/10 on, the reverb and delay tails are trailing off for several seconds and I turn Loop 4 on/off repeatedly... every time I do this the delay/verb trails are "dropping" for a moment.
Is this expected behavior? Is there anything I can do to prevent this, outside of putting the Strymons after the PBC?