I have an Effects Gizmo and an RG-16 in my rack. I have been using the stock AC wall warts up till now. I just purchased the MC403 for my pedals and realized I have no use for the 9 VAC outlets... well except they would be perfect for my RJM's. The outlets run at 800mA. I was under the impression that the RG-16 needed 1200mA if powering the Mastermind (which I wont be) but it will be fine with 550mA otherwise. Because all the outputs on the MC403 are isolated I am pretty sure I shouldn't run into any ground loops. I'm guessing this sure work fine and dandy?
I figured others might be in the same boat so I posted this question here before calling RJM with this question.
I figured others might be in the same boat so I posted this question here before calling RJM with this question.