Rick
Well-Known Member
Newbie shame... sent Ron a message but thought I'd venture a question here too.
Fired up the new MMGT/22, and was zipping around through the menus when I noticed my main screen had inverted (looks the way a preset does when you select it, except the lettering did not invert). Very hard to read this way, and I don't see a place where I could make that happen or undo it. It is working as normal, and changes with selections as it should. Just looks like the contrast went wild on me.
Tried factory reset, and loading new firmware. Anyone run into this? Ideas on how to "uninvert" it? Everything else is working fine, it's just the display on that window.
Fired up the new MMGT/22, and was zipping around through the menus when I noticed my main screen had inverted (looks the way a preset does when you select it, except the lettering did not invert). Very hard to read this way, and I don't see a place where I could make that happen or undo it. It is working as normal, and changes with selections as it should. Just looks like the contrast went wild on me.
Tried factory reset, and loading new firmware. Anyone run into this? Ideas on how to "uninvert" it? Everything else is working fine, it's just the display on that window.