Anyone here have any experience using the PCB10 to switch a Peavey Rockmaster? This is a 3 channel preamp with a two button foot-switch setup. I'm not sure it's wired for a standard two button two channel rig as the third channel (clean) is both switches off.
I'm putting together a board using two PCB 10 working in conjunction with one another. I'm wiring it so that there will be 12 mono and 8 stereo pedals. To that end I was going to hook up the two units this way:
Guitar -> Unit 1 input 1 -> Unit 1 out 5-6 (insert) -> Unit 2 input 1 -> Unit 2...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.