Search results

Thanks for the quick response! Ill probably just incorporate an expression pedal at this point. Thanks again!

Is there a way to automate knob movement on a midi controlled pedal using the PBC 6x? I assume, if possible, you would need to automate a sweep through the CC range of the desired effect. After looking through the editor, it is not totally apparent how to achieve that. Maybe its not possible...

Thanks a ton for your experience. If I think of something I'll let you know. Based on your analysis, I'm leaning on just using the H9 in mono at this point. I really only use it as a chorus, wah and for the octave effects since I use a Collider and Capistan to cover all delay and reverb needs...

I am rewiring my PBC 6x to accommodate a wet/dry/wet configuration. I wanted to check if I am planning this correctly or if there are going to be issues from this type of setup. I have attached a screenshot of my routing. The other potential issue would be with the H9 (which I primarily use...

Thanks for the quick Response! I made those changes to my config file, but wont be able to test it until tomorrow. I noticed that a lot the buttons have the send on preset change and update on preset change turned on and momentary turned off. I have not done this intentionally. Would it be...

I have my PBC 6x setup where page 1 is a directory page, page 2-5 are pages where I can access certain pedals and midi, then page 6 is where I access songs and presets. However I am running into an issue when selecting presets from songs on my 6th page. I have a bank up and down button that...