Hi,
I am looking to add foot switches to my Mastermind GT 16. I was looking at Laney FS2 Mini which uses 9V supply.
I think this will work fine and the LEDs will work if the FS2 Mini is pluged into the TRS and 9V ports on the GT 16.
I was wondering if the mastermind GT 16 TRS footswitch output...
Re: Debugerr "Unable to Contact Board 4" Can't PC, GetPrst n
I currently have it directly powered using the power supply into a power strip.
Thank you for the tip on the power drop. I'll keep an eye out.
Dave
Re: Debugerr "Unable to Contact Board 4" Can't PC, GetPrst n
I am using the power supply that came with the unit.
All power is goes through a Furman.
I did notice the source voltage getting low.
It was at 115V. Not sure if the MMGT is sensitive at those low levels.
So if the main display...
Re: Debugerr "Unable to Contact Board 4" Can't PC, GetPrst n
Hi
Thanks for getting back to me.
The chain of events went like this:
1. I programmed the MMGT16. Everything was working. I did multiple Get Preset Name sessions...no hiccups.
After a few days....
2. I went to do a Get Preset Names...
That's what I thought, as well. Seemed logical. Also noticed during boot that is does each row indicating a processor for each row.
I wouldn't spend to much time on reproducing the error. Probably a speed or noise issue as a result of a worn out usb port on the computer.
Thanks for the reply...
Hi
Just wanted to update everyone.
I tried using another computer and it seems to be working.
I only got one error which a midi read error.
I guess the usb on the other computer was noisy. It was a Dell E6400.
Thanks,
Dave
Hi,
I have lost the ability to control presets after setting up AxeFX II device in MMGT16.
Also I am unable to Get Preset Names.
I went into debug and noticed an error "Unable to contact board 4".
Is this related to the problem or a board that is for GT22?
Thanks,
Dave
Hi
Thank you for all of the replies. I will try another usb cable.
I am struggling with another problem.
I have now lost the ability to Get Preset Names and can no longer change presets.
I went into the debug log and saw "Unable to contact board 4"
I will post this in another topic.
Thanks,
Dave
Hi
99% of time the MMGT Editor fails to write to the GT16. The MMGT Editor locks up and I have to terminate the program.
I am using the current 1.4.5 editor and firmware.
Any insight?
Thanks,
Dave
Hi
Most of time when I try to write to the MMGT16 via the MMGT Editor (Win7), the write progress bar does not advance and I am forced to end the MMGT Editor program. All connections are secure and this error will occur after I have had a successful write session from Editor to GT16.
Any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.