Search results

Has there been an update to the MMGT Editor manual anywhere? I'm specifically looking for what the "send" command on a System / ExpPedal message does, but it would be nice to have a go to for other questions as well. The "old" manual is here -...

Hello! I've just noticed a problem with sending the CV output of an 8 Step through my GT 10. I've got the 8 Step running into an expression jack on the GT10 and then sending that via MIDI to various pedals. Previously it was working as expected, with a reversed TRS cable, but now it's only...

Are there any plans to include parallel paths in the MEG X?

As a Switchblade 8F owner I'm pretty stoked on the new Effect Gizmo. Thinking about selling one to get the other and wanted to see if anyone else had done it or is thinking about doing it. My main reasons for switching would be availability of stereo loops and well supported software to edit...

Has anyone tried / succeeded / failed to connect a Red Panda USB capable pedal like the Tensor to their GT for MIDI control? I really want that pedal, so I'm curious how much control I can get over it, if any, with my GT10.

Love seeing the BPM. Don't always need it to flash though.

I'm pretty sure I'm being dumb, but I can't figure out how to have a button that shows the current tempo without tapping a tempo button. Anyone know?

Has anyone solved using a single switch to control the H9 Performance switch in all of it's various implementations? I'm very close to just setting up 3 different switches to handle the 3 ways it interprets the switch… but I really don't want to.

Hello all - trying to use my 8 Step as Exp Pedal 2 on my MMGT and not having any luck getting anything to receive the information coming out of the 8 Step. Does anyone have any ideas on setting this up? I have it listed in the main setup and I'm sending to the correct CC numbers (specifically on...

Just spoke to Strymon about their Ojai RC30 power supply and you can use a Voodoo current doubler cable on both of the multi voltage outputs at 12v to get 750 mA total. I'm assuming I'll need a polarity switcher as well since the GT is center negative. Just thought I'd share for folks looking...