Search results

Thanks. I held down the 1 and 3 buttons while turning on the PBC and uploaded the firmware from that screen and it worked. Thanks, again.

Started uploading the new firmware on my PBC10. I haven't updated for awhile. I think I was on version 4.2 or 4.3. Right now it's just scrolling through this text and it's been doing that for about 10 or 15 minutes. I'm using a flash drive. I've posted a picture and a video of it. Is this...

Hey, all. I've noticed that the MIDI clock on my PBC will drift when set next to other independent metronomes or MIDI clocks even when I keep it on the same preset. For example, I send it through a Molten Voltage G-Quencer (effectively a sequencer), and my MIDI clock and sequence will drift...

Nevermind, I figured it out.

Hi, Is there a way to create custom button pages for particular presets while in Song/Setlist Mode? For example, I have a song that has 10 presets on it. So I've edited two of the buttons to be Preset + and Preset -. However, I'd like those buttons to go back to being normal Preset 4 and...

Yeah it says it receives MIDI Song Position Pointer, Start, Stop, and Continue messages. However, it also says that when it receives a MIDI Stop message it reverts to its own internal clock. So it sounds like maybe it doesn't actually stop the sequence when receiving a Stop message. To add...

Awesome, thanks! I used the second option by creating an IA button in the place of the Global Preset. I attached a Sysex Start and Stop with the On and Off of that button (respectively). When I pressed it On it started the sequence over, which is good. But when I pressed it Off it didn't do...

I've got a Dream Sequence by Hologram Electronics. In the manual, it says that the Dream Sequence can receive MIDI Start/Stop Sequence messages. In the MIDI breakdown section it says that the MIDI message type "Start" has a function "Sequencer Start" and the Range is "N/A". So what type of CC...