Hello,
I'm not sure I'm not the first one here to immediately purchase the incredible Tonex pedal and want to incorporate it into their PBC rig. For me, it's caused me to pull my PBC10 out of the closet and start rebuilding my pedalboard, retiring my Kemper, probably for good. I was wondering -...
Even without running any pedal loops, still get a volume differential between output A and output B. I eliminated all cabling to test - still a delta between A and B roughly as pictured in the screen capture with DAW levels consistent. Mono output in. Guessing the level differential is...
Just ran a test in mono, and the B output has a slight volume drop. Any thoughts on what might cause that? I think the only thing I need to do in terms of rewiring is to create stereo splitter cables. Otherwise it seems I'm set up.
I have the Volante and my reverb pedal set at line level so...
To close out, I replaced the cable from out 5-6 to my volume pedal and the issues are gone. Oddly, maybe, the "bad" cable that I replaced tested find on a live wire cable tester.
Ok, hopefully the post title makes sense. I'm sure I have my terminology wrong, but here's what I'm doing anyway. My goal is to run stereo effects post speaker cabinet.
1. Mono effects to front of a single amp (using out 5-6)
2. Out from a Suhr Reactive Load IR to in 7-10 (sort of the digital...
I seem to have found the issue by accident. Maybe. The problem partially flared up again with Loop 3 engaged. I noticed the cable to my volume pedal makes a bit of noise when I touch it, but it seems only with Loop 3 engaged (?). I moved it and volume came back, and the scratchiness went...
Thanks Ron. I kinda unplugged and tested everything in a somewhat haphazard way because I was in the middle of other things (gotta love working from home for that!). I didn't do a good job of going through things one by one so I'm not sure what it was, but its fixed now...
Hello,
I'm running into what I hope is just an anomaly, but its a rather soul crushing one at that! This is the first time having these issues, hoping someone can help. Note that I did just rewire my board, but its wired correctly to the instruction manual for single amp effects loop...
Hey all,
I've noticed that the delay tempo using auto taps is out of time with delay using midi clock for tempo. Here's the setup:
TC Flashback 2 into the front of the amp (tempo set by auto taps)
Strymon Volante into the effects loop (tempo set by midi)
Both set to dotted eighths (using...
Hey all,
I'm brand new to the PBC10, so bear with me if this is actually completely obvious. :) I'm currently running loops 1-6 into the front of an amp and 7-10 into the effects loop of that same amp. Sounds great, but I have a second amp that I would like to incorporate into the set up. I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.