Search results

I purchased an older RG-16 (no ground lift switch) as a back-up to my Rack Gizmo and Mastermind rig. I need to reset the unit to factory defaults because the RG-16 doesn't communicate correctly with my Mastermind. Is there a way to do so?

Is there a way that I could wire my two stereo FX processors in parallel using only the Rack Gizmo/RG-16 if the only thing running through the RG are the two FX processors in an amp's loop without having to use a line mixer? (I have no FX pedals in my rig). Maybe y cables to split the dry...

My Global Function Select switch works only intermittently. I pulled the board and operated the switch with my finger to confirm it doesn't work. Is this a bad pad? Or is the another component going bad. If its the switch, can you recommend a replacement part number? I have firmware version 1.4.

I am a happy Rack Gizmo owner and I recently purchased a used RG-16. Last week it started giving me trouble not passing sound thru loops 2 and 3. Tonight it quit passing sound at all. I am relatively handy with a multi meter and a soldering iron, but I'm not an electrician. Where should I start...

I purchased an early RG-16 (pre-ground loop button) and it does not pass a signal thru the buffer in/out loop. Do you have any troubleshooting tips? Should I try replacing the LM833N opt amp? I have a NTE778A, isn't it comparable? The specs on the NTE778A look very similar to the LM833N...

Is there a way to run more than 4 effects in the amp loop and still run at least 1 effect in front of the amp? I cannot figure a way to do this.