matt-phaeleh
Well-Known Member
I've just been tidying up my setup this evening, and randomly any button which use IA cycles no longer lights up.
They appear greyed out (unlit) on the GT16 and in the editor too, though they still cycle through the steps and function correctly otherwise.
The same buttons light up perfectly for any other type of button. If I turn IA Cycle off, the button lights up as normal, if I turn IA Cycle back on, it no longer lights up again.
I've only been doing minor changes, but I can never rule out human error on my part, just wondered if anyone had come across anything similar? I've reinstalled the latest firmware, and the only other factor I could think of was that I started working on OSX, then switched to Windows 7, but I do this frequently without any other previous problems.
Any suggestions of boxes to untick or settings to change, no matter how obvious will be much appreciated!
They appear greyed out (unlit) on the GT16 and in the editor too, though they still cycle through the steps and function correctly otherwise.
The same buttons light up perfectly for any other type of button. If I turn IA Cycle off, the button lights up as normal, if I turn IA Cycle back on, it no longer lights up again.
I've only been doing minor changes, but I can never rule out human error on my part, just wondered if anyone had come across anything similar? I've reinstalled the latest firmware, and the only other factor I could think of was that I started working on OSX, then switched to Windows 7, but I do this frequently without any other previous problems.
Any suggestions of boxes to untick or settings to change, no matter how obvious will be much appreciated!