stringtheorist
Well-Known Member
Thought I had all this nailed down but after running through my presets I notice that the response of my Kemper is glitchy to Stomp on/off PC commands from the PBC.
Fore example, the Kemper will show the correct Stomp on/off state but the audio signal will reflect a different Stomp state (dry instead of wet, etc.)
At this point, I am not sure if there is a problem with the PBC, the Kemper or (more likely) user error. Note: I am still seeing an error alert on the Kemper at each preset change that says "Module is empty! Please select a type or preset."
Fore example, the Kemper will show the correct Stomp on/off state but the audio signal will reflect a different Stomp state (dry instead of wet, etc.)
At this point, I am not sure if there is a problem with the PBC, the Kemper or (more likely) user error. Note: I am still seeing an error alert on the Kemper at each preset change that says "Module is empty! Please select a type or preset."