I have a couple pedals that have mono inputs with stereo outputs. I would like to set them both up and was wondering what the best way to approach this is. I never use these pedals with mono in/stereo out (chorus and phaser) at the same time. It's one or the other. Here's my plan:
7 - Phaser - mono in/stereo out
8 - Chorus - mono in/stereo out
9 - Delay - stereo in/stereo out
10 - Reverb - stereo in/stereo out
I would also like to be able to bypass both the phaser and chorus, while still having a split stereo signal sent to the delay and reverb. To accomplish this, would I leave the mono -> stereo switch in the "out" position and use a TRS with the rings disconnected on the sends of 7 and 8? Or could I use a standard TS plug instead? Any issues with this setup that I'm not considering?
7 - Phaser - mono in/stereo out
8 - Chorus - mono in/stereo out
9 - Delay - stereo in/stereo out
10 - Reverb - stereo in/stereo out
I would also like to be able to bypass both the phaser and chorus, while still having a split stereo signal sent to the delay and reverb. To accomplish this, would I leave the mono -> stereo switch in the "out" position and use a TRS with the rings disconnected on the sends of 7 and 8? Or could I use a standard TS plug instead? Any issues with this setup that I'm not considering?