mystery

Victor Vos

Victor Vos

Well-Known Member
I have a very strange issue (again) about (bidirectional) communication (GT 10 - AxefxIII):
When I scroll through my setlist on my GT to a specific song it jumps to a different song.
When I select it from the setlist (song menu) it works fine. I don't find any extra unwanted messages/actions in the presets or songs or in the presets on the Axefx... This may also happen on other songs or presets, I have not tried all...
 
Try turning off Poll State if you have set up Songs using Scenes within one preset instead of the official way of using multiple GT presets. I had a similar issue recently. Of course then unfortunately it won't update the state of your blocks, scenes, etc. if you change them on the AxeFX3. Ron describes what might be happening in this post: https://www.rjmmusic.com/forum/inde...-setlists-feature-on-axe-fx-3.6229/post-32998

If this is what is causing your problem and you want if you want to keep Poll State on and use Songs the "proper" way, @Neill00 has shared some Song setup template files here: https://www.rjmmusic.com/forum/inde...d-setlists-template-for-6-song-sections.6239/
I haven't tried it this way yet but it looks like it would have some positives.
 
Last edited:
Pagzy said:
Try turning off Poll State if you have set up Songs using Scenes within one preset instead of the official way of using multiple GT presets. I had a similar issue recently. Of course then unfortunately it won't update the state of your blocks, scenes, etc. if you change them on the AxeFX3. Ron describes what might be happening in this post: https://www.rjmmusic.com/forum/inde...-setlists-feature-on-axe-fx-3.6229/post-32998

If this is what is causing your problem and you want if you want to keep Poll State on and use Songs the "proper" way, @Neill00 has shared some Song setup template files here: https://www.rjmmusic.com/forum/inde...d-setlists-template-for-6-song-sections.6239/
I haven't tried it this way yet but it looks like it would have some positives.
Click to expand...
Yes I think this is the same issue... Thanks!
 
Victor Vos said:
I don't think so.. I update all..
Click to expand...
I recall what happened to me at one point was I updated a section and my number reference did not match, so the patches were off and when scrolled out of the short list I updated, it didn't sync up right. I scratched my head for a while on it...but I recall I read someone else had a similar problem...that's what prompted me to look at it closer. I haven't changed mine in quite a while as I use both the PBC10 and the GT22 in different configurations, some with the axe, some conventional amps. I usually just flash my board for whatever configuration I need. It sort of stays the same at this point for each setup.
 
You must log in or register to reply here.
Back
Top