ataglianetti
Well-Known Member
I recently added a Hologram Electronics Microcosm to my pedalboard and just finished setting it up as a device in the PBC 6X.
Unfortunately I'm experiencing an issue when my pedalboard is powered on or when I use the Mastermind editor to send updates to the PBC6X. When my board is powered up or the PBC6X receives an update from the editor, the Microcosm goes into update mode - which according to Hologram Electronics, means it's received SysEx data.
The Microcosm is the last device in my MIDI signal flow. Before it is a Chase Bliss Audio MIDI Box, Strymon Volante, and Strymon Big Sky. The other devices are fine.
Is there a way to not send sysex data to the MIDI devices on power up or receiving an update from the editor? I have to power cycle the Microcosm independently each time this happens.
I'm on Mastermind Editor / PBC 6X FW 4.4.2.
Unfortunately I'm experiencing an issue when my pedalboard is powered on or when I use the Mastermind editor to send updates to the PBC6X. When my board is powered up or the PBC6X receives an update from the editor, the Microcosm goes into update mode - which according to Hologram Electronics, means it's received SysEx data.
The Microcosm is the last device in my MIDI signal flow. Before it is a Chase Bliss Audio MIDI Box, Strymon Volante, and Strymon Big Sky. The other devices are fine.
Is there a way to not send sysex data to the MIDI devices on power up or receiving an update from the editor? I have to power cycle the Microcosm independently each time this happens.
I'm on Mastermind Editor / PBC 6X FW 4.4.2.