Hi
My amp uses a mono cable to switch channels.
I've tried a couple of different cables (mono, trs > trs, trs > split)... the odd thing is that for both Func switch outputs, I can only switch my amp if BOTH switches are "on". From looking at the manual I would guess that either "1" or "3" should be on (tip) to make this work (not BOTH "1 + 2" or "3 + 4").
Is there a setting in the editior to adjust this? Or perhaps is my unit wired incorrectly?
Thanks!
-kb
My amp uses a mono cable to switch channels.
I've tried a couple of different cables (mono, trs > trs, trs > split)... the odd thing is that for both Func switch outputs, I can only switch my amp if BOTH switches are "on". From looking at the manual I would guess that either "1" or "3" should be on (tip) to make this work (not BOTH "1 + 2" or "3 + 4").
Is there a setting in the editior to adjust this? Or perhaps is my unit wired incorrectly?
Thanks!
-kb