Gordon
Active Member
I have a Chase Bliss Tonal Recall and Gravitas Tremolo, as well as a Source Audio Collider pedal wired up for MIDI to my PBC 10. I'm using an external switch for a global tap tempo for all three devices, which has CC Momentary #93 off:0 on:127 IA Actions assigned for all three devices. The two CB pedals are connected via TRS to a Disaster Area Midi Box 4, set to "ring active" as instructed, and have identical settings in the Devices tab of the Mastermind Editor (other than separate MIDI channels). PBC firmware is 4.5.0.
The Gravitas and Collider are both receiving tap tempo as expected, but the Tonal Recall is not.
I have tried different TRS cables with no success. I even reached out to Chase Bliss and they're stumped. Each pedal is assigned it's own MIDI channel on the PBC corresponding to its internal channel setting. Any ideas for what might be going on and how I can get the TR receiving MIDI properly? It doesn't appear to be receiving PC messages either.
Note: this is my 2nd TR to encounter this same issue, having recently upgraded to the Red Knob Mod, so I kinda doubt it's just a defective pedal.
The Gravitas and Collider are both receiving tap tempo as expected, but the Tonal Recall is not.
I have tried different TRS cables with no success. I even reached out to Chase Bliss and they're stumped. Each pedal is assigned it's own MIDI channel on the PBC corresponding to its internal channel setting. Any ideas for what might be going on and how I can get the TR receiving MIDI properly? It doesn't appear to be receiving PC messages either.
Note: this is my 2nd TR to encounter this same issue, having recently upgraded to the Red Knob Mod, so I kinda doubt it's just a defective pedal.
Last edited: