Recent content by satch4u3

Part received and installed. Back in working order. Thanks again.

No worries. I found this pretty quickly. Can you confirm this would be the correct part? https://www.digikey.ca/en/products/detail/c-k/KSL0M412LFT/1003906

Hi Ron, I ordered and received the part that you specified, but what they sent me looks nothing like what’s attached to the board of the MMGT16. Attached below is a picture of the part that I received based on the link that you provided. I reached out to mouser notifying them that I believed...

Ok I can certainly handle installing this. Thanks so much for this.

Hi, One of the buttons that is used to update the firmware on my MMGT16 seems to have broken away from the PCB board. The left button be exact. I assume that this isn't an easy fix as I have opened up the unit to have a look and it's underneath a number of PCB boards. This is the third issue...

Hi, I am considering one of your PBC switchers but wanted to run a setup by you guys to see if what I am thinking about doing will work, and which of the the PBC switchers would be best suited for the task. I am sure it can be done but I just can't wrap my head around some of audio In's and...

Yes that would be great. Thank you.

Hi Ron, I’m located in Newfoundland, Canada. Edit: I am currently powering it with your phantom power box over 7 Pin midi.

Hi, I took my GT16 out if its gig bag for a setup and sound check yesterday, and heard something rattling around inside. Once I got home I opened it up and found whats in the attached pic. I managed to get through the sound check and the GT16 seemed to function fine. What is it and where did it...

I can confirm that it's working now. Thanks, Ron!

I did try resetting to factory defaults as well and the behaviour is the same. So I am not sure my settings file will make any difference.

I am using Windows 10. I tried to upload the settings file but it said that it was too large. 2,169kb

Rolled everything back to 4.7.0 and it all works as it should.

Hi. I have updated both the editor and firmware to 4.8.1 and now the editor won't do a "Read Settings from device". The editor shows that it's connected and I can push settings from the editor to my GT16.

That was it! You're the best Ron. Thank you.