Hello,
I recently picked up an Axe FX III and have it successfully connected and working with my Mastermind PBC.
However, I'm having issues getting my SP1-RJM expression pedal working. I don't know if this is a PBC or Axe FX III config issue so I'm reaching out here for help..
I followed...
I'm still struggling with my stereo setup. I was running everything to the front of both of my amps and it all worked perfectly. In fact I loved the blend of the two amp tones together. But since the only pedals I really use are stereo Reverb/Delay/Chorus I want to get them in the FX loop to...
Hello, wondering if I could get some input on something. I've been running two guitar amps in stereo - a Mesa Mark V and a Marshall DSL100, and I also send some pedals to a Bass amp to get those lower frequencies. As I'm in a 2 piece band - (just me and a drummer) I like to have a big guitar...
I'm looking to finally replace my Marshall DSL100 with a Mesa Triple Crown. I run dual amps in stereo, and plan on stacking a Mark V on top of the Mesa TC100. I'd like to have one interface cable running to the PBC to handle channel switching, SOLO etc. on both amps.
So my question is, can I...
I still haven't finished wiring up my pedalboard because I'm having way too much fun experimenting with the PBC, different amps, pedals, etc.. I'm not sure how to finish it off because I'm trying to find the optimal way of moving my stereo delay from before the preamp into the effects loop. I...
Hey all,
I've been running all my effects before the preamp of my Mark V for quite some time. Thought I'd try out the effect loop instead to see what I prefer. Everything was routed correctly, I set the loop to active on the amp and made sure the send level was turned up but the pedals in the...
Hello, I just ordered myself a RJM-SP1 expression pedal to go with my Mastermind PBC. Looking forward to setting it up to work with my MIDI enabled pedals! Quick question - can this expression pedal also be programmed to act as a volume pedal and if so how can this be done?
I have a stereo setup and have been noticing a delay when toggling Output B. When I toggle Output A on/off the response is immediate. When I toggle Output B on/off there's a noticeable delay in signal. In an effort to rule out the cable and amp I swapped output cables between A and B to see...
I'm in the process of preparing to properly wire up my pedalboard. Just curious about opinions on use of a wah pedal. Is there any benefit to keeping the wah pedal in a loop on the PBC? As it will always be my first device and it will be the first device on the bottom right of the pedalboard...
Ok, I've complicated my world even further. I'm running two amps in stereo with the PBC, but on one of my loops I have a Micro Pog and I'm sending the wet out of the Pog into a Bass Amp. It ends up creating a massive sound, dual guitar amp tone and bass tone all from a single guitar! However...
Hello, I just received my PBC and I'm trying to sort out some basics... so please bear with me!
I've read through a lot but I'm clearly missing something. I simply want to know where in the software editor you set presets to alter FN Switches (for channel changing on amps)
I went under Preset...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.