Selecting any preset from 000 to 127 works correctly. Selecting 128 and beyond "folds back" to 000 to 127. Selecting preset 128 brings up preset 000. Selecting preset 129 brings up 001, etc. Perhaps that is a setting on the Axe-FX III? I see the correct higher preset name for a split second on the GT22 display, but it then immediately switches to the 000-127 preset.
Hi, not sure if you've checked these settings but here you go...
Axe FX III Settings:
There are a few important settings that need to be made on the Axe-Fx III. Go into setup on the Axe-Fx III, and use the "down" button to move down to the MIDI/Remote option, then press Select. Make the following changes:
1-Set MIDI Channel to 1
2-Set Program Change to On
3-Set Send Realtime Svsex to On
Setup on the Mastermind G requires onlv a few steps:
1-In Mastermind GT setup, select Edit Devices.
2-Select a device slot. If vou're starting with a Mastermind GT that's in the factor state, select the "Effect Gizmo" slot and vou can overwrite it. If vou also have an Effect Gizmo. vou can leave the "Effect Gizmo" entry and instead select one ot the empty slots.
3-Press the Type button, then select Fractal Audio. Next, select Axe-Fx III.
4-Press the Set Default Buttons button and press 1. This sets up button page 1 with a default set of buttons that control the Axe-rx I.
5-Press the Set Default Pedals button. This sets up the GT's expression pedals to control the Axe-Fx
There's a little more expression pedal setup required on the Axe-rx. which is described in the next
subsection
6-Optional: Use the Get Preset Names feature to read the preset names from the Axe-rx. This process Is
described in the reading Preset Names with scenes section
7. Exit setup mode.