Search results

I'm replacing my HX stomp with an Eventide H90 on my board. I used the HX mostly for effects and not the amp models and speaker cabs etc. What is the best way to connect the H90 to the 6X? I had the HX stop wired as below so I could use the preamps and fx wherever I wanted to in the chain...

Just redoing my board a little and when I was hooking up the power supply ( Voodoo Lab 3 Plus ) I rechecked the MA of the 6X and it said power either 9 or 12 VDC 220 ma. I have the option for 9 or 12 VDC. What is the difference of running one over the other? Is 12VDC optimal? I had been running...

How do you save individual presets on the 6X? I am using an HX stomp with my 6X and would like to save presets I have made from these two connected so when I do a gig I can load them from a folder on my MAC into any preset slot open the 6X. I figured that saving the 6X preset is the way to do...

I gigged with my PBC/6X for the first time last night. At random times it would just jump to a high number preset in the 300s. I had to turn it off and on again 3 times mid song during my set to reset it. Once it powered back up it was back to my presets and was fine until it happened again. I...

First time MIDI user. I have my HX wired up 4CM in loops 5 and 6 and INS. Looking for any newbie tips in accessing FX and programs of th HX via the 6X. I know that in the editor I can add the HX to the Devices. Do I have to change any other values to the HX, 6X, or Editor to communicate between...

Is it possible to use both the EXP and VOL IN/OUT simultaneously on the DVP5 ? I am trying to figure out the best way to hook it up to the RJM PB6X and HX Stomp. By simultaneously I just meant using the outputs the same time to send to two different units. I could use the expression to control...

I've decided to incorporate an HX Stomp into my rig to use along with pedals and my 6X. I would like to use it for mostly FX ( but maybe a few amp sims as well) from the Stomp via MIDI in my 6X presets for different songs. I did do a search before posting but I'm not sure I found an easy way to...

When making presets in the editor and using the FN switch to change channels on my amp, Does FN switch 1 denote the clean channel and FN Switch 2 the OD channel ? So if I want a clean preset select FN Switch 1 etc. ? What happens if both FN Switches 1 & 2 are selected ? The amp is a Mesa...

If I am using the INS loop as an extra mono loop for a pedal how do I access it from the loops page if the buttons are only loops 1 through 6? Do I have to assign it to the function switch? Thanks in advance!

This is a brand new venture for me and feel a little overwhelmed. Always been a pedal guy but not experienced in programming a switcher etc. I wanted a loop switcher to make it easy during songs in my set to turn on multiple pedals at once and after a ton of research I bought the PBC/6X for its...