Hello. I have PBC 10 with an overture. For some reason the overture does not send midi clock info from PBC out of its midi out port? I have swapped cables etc. The device before is an H9 and I have confirmed it is passing midi clock on.. The device after is an H90 and it receives program...
Wow!! That’s a fast response... so the way that works is each time you rock pedal forwards it chooses the other preset (which is great ) is there a way to make heal up one preset and heal down the other?
Hello...using PBC 10 and trying to figure out how to alternate between two presets on PBC with expression pedal ( ie up is one preset down is the other). If I set up expression to system/preset/alternate it changes to alternate but then stays there...how do I get it to toggle between the two...
Can confirm that bugs are fixed up. Killdry on when it says it’s on. Still couldn’t figure out how to write to pedals using PCB midi in to connect ( reads from both pedals with no problems but can’t write back). Plugged directly into pedals all works as it should.
As I said I have not tried them yet....hope it was OK to post it here. Matt did not indicate that it was a Beta. I will load them up today and report my experience
Not sure if this has already been posted (couldn't find it when I searched ) but the bug that was present in the firmware update allowing the Big Sky and Timeline to work with Nixie ( the bug made the pedal think that it was in Kill Dry when it was not ) is apparently fixed according to Matt at...
Hey Scott...as Ron mentioned earlier in this thread a volume increase should not happen at all if the units are really in Killdry. You are not by chance running the Beta firmware for the Strymons ( that allows Nixie). There is a bug that makes the unit actually not in killdry even though it...
I built the 2nd tier myself... just a piece of plywood, two end pieces and a few strap hinges... works really well... lots of goodies in a small footprint. The road case was one I have had for years.. used to house my G System before I switched to the PCB... the company that made it has since...
A pedal that I believe is underrated is the Nova Drive by TC. It is an anolog OD and Distortion pedal with complete midi control.. I have had one on the board for years and could not live without it. It plays very nicely with PBC. I use the expression pedal to control gain levels on the...
More from Matt at Strymon
Matt Alegrete (Strymon)
Dec 13, 10:50 AKST
Hello David,
No problem! Hopefully we should have a new version of Nixie in a few months, but I am not sure how soon we can get everything ironed out. I am attaching both firmware files into this email.
To load them...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.